CHAPTER 2
CHAPTER 2
CONNECTING THE UNIT
29
28
STEP 3 - OPTION 2 - CONNECTING TO THE VEHICLE'S POWER
SUPPLY (RECOMMENDED METHOD)
STEP 3 - OPTION 1 - CONNECTION TO THE CIGAR LIGHTER
SOCKET
1.
Use the cable supplied (part C). Make sure the cable is long enough to reach the
power supply, then remove the lighter plug and any excess cable.
2.
Locate the connection points in the vehicle using the diagram below. The black
ignition signal wire should be connected to the vehicle ignition.
RED
+12V / +24V Power
BLACK
+12V / +24V Ignition
WHITE
Earth
3.
Before connecting the cables to the vehicle, install 5-amp fuses (not supplied)
in series with the power wires (red & black).If the vehicle's power supply is already
protected, this step is not necessary.
4.
Finally, connect each wire to the previously identified points (vehicle power,
ignition and earth).
This installation should be carried out by a qualified vehicle electrician.
Axxès cannot be held responsible for any damage or an incorrect
installation.
Connect the cigarette lighter socket to the vehicle plug and check that :
- The plug is securely connected.
- The cable will not get in the driver's way.
NB:
However, we recommend a connection to the vehicle power supply (see
next page).
The unit must be plugged in to comply with the rules of the networks
subject to tolls and taxes.
CONNECTING THE UNIT
