Axxess AX-CH013-SWC, Installation Instructions Manual

CAUTION! 

 All accessories, switches, climate 

controls panels, and especially air bag indicator 

lights must be connected before cycling the 

ignition. Also, do not remove the factory radio 

with the key in the on position, or while the 

vehicle is running. 

AX-CH013-SWC

I N S TA L L AT I O N I N S T R U C T I O N S

AxxessInterfaces.com 

© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION 

REV. 7/25/18 INSTAX-CH013-SWC

INTERFACE FEATURES

INTERFACE COMPONENTS

TABLE OF CONTENTS

Connections to be made ................................... 3-6
- For models without an amplifier .......................3
- For models with an amplifier ............................4
- 3.5mm jack steering wheel control retention ..5
Installing the AX-CH013-SWC ................................5
Programming the AX-CH013-SWC ........................6
Adjusting the AX-CH013-SWC ................................6
Steering wheel control settings ....................... 7-9
- L.E.D. feedback ....................................................7
- Changing radio type ...........................................7
- Remapping the steering wheel control buttons ...8
- Dual assignment instructions (long button press) ...9
Troubleshooting ................................................... 10

Chrysler

 Data Interface with SWC

2004-up*

•  Provides accessory power (12-volt 10-amp)
•  Retains R.A.P. (retained accessory power)
•  Provides NAV outputs (parking brake, reverse, speed sense)
•  Retains audio controls on the steering wheel
•  Retains safety chimes (LD-BX-CH4 applications)
•  Can be used in both amplified and non-amplified models
•  Retains balance and fade (non-amplified models only)
•  Retains Blind Spot Detection (if equipped)
•  Includes antenna adapters for both generations of vehicles
•  Micro “B” USB updatable

• AX-CH013-SWC interface
• LD-BX-CH3 harness
• LD-BX-CH4 harness
• 16-pin harness with stripped leads

• 4-pin harness with stripped leads
• Female 3.5mm connector with stripped lead
• Antenna adapters (2)

*Visit 

AxxessInterfaces.com

 for up-to-date vehicle specific applications.

TOOLS REQUIRED

• Wire cutter • Crimp tool • Solder gun • Tape 

• Connectors (example: butt-connectors, bell caps, etc.)

• Small flat-blade screwdriver

APPLICATIONS

See inside front cover