Axxess AXDIS-CH13, Installation Instructions Manual

6

Audio level adjustment (amplified models only):

  •  With the vehicle and radio turned on, turn the volume up 3/4 of the way.
  •  With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio 

level; counterclockwise to lower the audio level.

  •  Once at a desired level, audio level adjustment is complete.

For the steps below, the L.E.D. located inside the interface can only be seen while active. The 
interface does not need to be opened to see the L.E.D.
  •  Start the vehicle.
  •  Connect the AXDIS-CH13 harness to the wiring harness in the vehicle.
  •  The L.E.D. will initially turn on solid 

Green

, then turn off for a few seconds while it auto 

detects the radio installed.

  •  The L.E.D. will then flash 

Red

 up to (18) times indicating which radio is connected to the interface, 

and then turn off for a couple of seconds. Pay close attention to how many 

Red

 flashes there 

are. This will help in troubleshooting, if need be. Refer to the L.E.D. feedback section for more 
information.

  •  After a couple seconds the L.E.D. will turn on solid 

Red

 while the interface auto detects 

the vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.

  •  Once the vehicle has been auto detected by the interface, the L.E.D. will turn on solid 

Green

, and the radio will come back on, indicating programming was successful.

  •  Test all functions of the installation for proper operation, before reassembling the dash. If 

the interface fails to function, refer to Resetting the AXDIS-CH13.

Note:

The L.E.D. will turn on solid 

Green

 for a moment, and then turn off under normal 

operation after the key has been cycled.

PROGRAMMING

ADJUSTMENTS