9
REV. 11/2/2020 INSTAXDSPL-GM30
Continued on the next page
MOBILE APP
(CONT.)
Configuration
•
Identify
- Click this button to send a test tone to the front left speaker*.
* Only installations using the front left output (white RCA jack).
•
Reset to Defaults
- Resets the interface to factory settings. During the reset process the amp(s)
will shut off for 5-10 seconds.
•
Vehicle Type
- Select the vehicle type from the drop down box, then click the apply button.
•
Lock Down
- Click this button to save the selected settings.
Attention!
This must be done before closing the app or cycling the key otherwise all new
changes will be lost!
•
Save Configuration
- Saves the current configuration to the mobile device.
•
Recall Configuration
- Recalls a configuration from the mobile device.
•
About
- Displays information about the app, vehicle, interface, and mobile device.
•
Set Password
- Assign a 4-digit password to lock the interface. If no password is desired, use
“0000”. This will clear out any currently set password. It is not necessary to lock down the
interface when setting a password.
Note:
A 4-digit only password must be chosen otherwise the interface will show “password
not valid for this device”.
•
Disconnect
- Disconnects the interface from the app.
