background image

AXGMLN-09

I N S TA L L AT I O N I N S T R U C T I O N S

AxxessInterfaces.com 

© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION 

REV. 2/4/20 INSTAXGMLN-09

Attention!

  

Let the vehicle sit with the key 

out of the ignition for a few minutes before 

removing the factory radio. When testing the 

aftermarket equipment, ensure that all factory 

equipment is connected before cycling the  

key to ignition.

TOOLS REQUIRED

• Crimping tool and connectors, or solder gun, 
  solder, and heat shrink • Tape • Wire cutter
• Zip ties • Small flat-blade screwdriver

OPTIONAL ACCESSORIES

 (sold separately)

Extension Harness: AXEXH-GM09
Steering Wheel Control Interface: AXSWC

TABLE OF CONTENTS

Connections .........................................................2-3
Installation .............................................................3
Programming .........................................................3
Adjustments ...........................................................4
Troubleshooting .....................................................4

APPLICATIONS

CHEVROLET

Colorado 

(1)

 

2015-2018

Equinox 

(1)

 

2018

Malibu 

(3)

 

2016-up

Silverado 2500/3500 

(2)

 

2015-2018

Silverado 1500 

(2)

 

2014-2018

Suburban 

2015-up

Tahoe 

2015-up

GMC 

Canyon 

(1)

 

2015-2018

Sierra 2500/3500 

(2)

 

2015-2018

Sierra 1500 

(2)

 

2014-2018

Yukon / Yukon XL 

2015-up

• (1)

 

With RPO code I05 or I06

 

 

(2)

 

With RPO code I03, I05, or I06

 

 

(3)

 

With Base model radio, RPO code IP1

The IOA/IOB code, if applicable, can be found in the 

Service Parts Identification

 label located: 

Glovebox:

 Canyon/Colorado/Cruze/Equinox/Silverado/Sierra – 

Rear Compartment Floor:

 Malibu

INTERFACE FEATURES

GM

 Data Interface

 

2014-Up

•  Provides accessory power 

(12-volt 10-amp)

•  Retains R.A.P. (retained 

accessory power)

•  Provides NAV outputs (parking 

brake, reverse, speed sense)

• 

Designed for non-amplified models

•  Retains OnStar/OE Bluetooth

•  Retains all warning chimes
•  Adjustable volume for chimes 

and OnStar

•  Retains the AUX-IN jack
•  Prewired AXSWC harness 

(AXSWC sold separately)

•  Retains balance and fade
•  Micro-B USB updatable

Visit 

AxxessInterfaces.com

 for more detailed information about the product and up-to-date 

vehicle specific applications

INTERFACE COMPONENTS

• AXGMLN-09 interface • AXGMLN-09 harness
• 16-pin harness with stripped leads

Summary of Contents for AXGMLN-09

Page 1: ...burban 2015 up Tahoe 2015 up GMC Canyon 1 2015 2018 Sierra 2500 3500 2 2015 2018 Sierra 1500 2 2014 2018 Yukon Yukon XL 2015 up 1 With RPO code I05 or I06 2 With RPO code I03 I05 or I06 3 With Base model radio RPO code IP1 The IOA IOB code if applicable can be found in the Service Parts Identification label located Glovebox Canyon Colorado Cruze Equinox Silverado Sierra Rear Compartment Floor Mali...

Page 2: ...he ground wire Connect the Yellow wire to the battery wire Connect the 2 Red wires to the accessory wire Connect the Green wire to the left rear positive speaker output Connect the Green Black wire to the left rear negative speaker output Note There are 2 Green Black wires Use the shorter of the two Connect the Purple wire to the right rear positive speaker output Connect the Purple Black wire to ...

Page 3: ...ew seconds the L E D will turn on solid Red while the interface automatically programs to the vehicle The radio will shut off at this point This process should take 5 to 30 seconds 4 After the interface is programmed the L E D will turn on solid Green and the radio will come back on indicating programming was successful 5 Test all functions of the installation for proper operation before reassembl...

Page 4: ...s and then with a small flat blade screwdriver turn the potentiometer clockwise to raise the chime level counterclockwise to lower the chime level Note The potentiometer is located on the side of the interface where the 16 pin harness with stripped leads is connected to 3 When the chime level is at a desired level remove the key from the ignition This will lock the chime volume at its current leve...

Reviews: