Axxess BX-GM6, Installation Instructions Manual

BX-GM6

3

Connections to be made

The following (3) wires are for the aftermarket radios that have navigation built in:

•  Connect the 

Green/Purple

 wire to the reverse wire (if applicable).

•  Connect the 

Light Green

 wire to the parking brake wire (if applicable).

•  Connect the 

Blue/Pink

 wire to the speed sense (V.S.S) wire (if applicable).

From the BX-GM6 harness:
(a) 30-pin harness to the aftermarket radio:

•  Connect the 

Black

 wire to the ground wire.

•  Connect the 

Yellow

 wire to the battery wire.

• 

Connect the RCA jacks to the audio AUX-IN jack (if so equipped).

 Note: 

This will only be required if you care to retain factory satellite radio.

Amplified vehicles:

•  Connect the 

Purple

 wire to the right rear positive speaker output.

•  Connect the 

Purple/Black

 wire to the right rear negative speaker output. 

•  Connect the 

Green

 wire to the left rear positive speaker output. 

•  Connect the 

Green/Black

 wire to the left rear negative speaker output. 

•  Disconnect the 4-pin connector located between the 30-pin and 22-pin 

connectors, and then connect the supplied 4-pin to 4-pin resistor pad harness.

Non-amplified vehicles:

•  Cut the resistors from the 

Green

, 

Green/Black

, 

Purple

, 

Purple/Black

 wire 

right below the heat shrink.

•  Connect the 

Purple

 wire to the right rear positive speaker output.

•  Connect the 

Purple/Black

 wire to the right rear negative speaker output. 

•  Connect the 

Green

 wire to the left rear positive speaker output.

•  Connect the 

Green/Black

 wire to the left rear negative speaker output.

•  Leave connected the two 4-pin connectors located between 

the 30-pin and 22-pin connectors.

 Note: 

The resistor pad harness will not be used in this application.