Complete * Schaumburg, IL 60173 *
Phone:
888
-
392
-
9947
6
OPERATING INSTRUCTIONS
Loading fasteners
Press the latch mechanism and open magazine unit.
Load fasteners into the magazine.
Close the magazine.
Type of actuating and trigger system
Dual action safety / contact safety:
it will be necessary to activate the contact safety mechanism as well as the
trigger in order to fire a fastener. By keeping the trigger activated and activating the contact safety a fastener is
fired, this allows for high speed firing, also known as bump firing.
Operating procedures
Protective equipment:
before using any tool always ensure that you and those in the work area are using the
appropriate working equipment, including safety goggles.
Firing a fastener:
to fire a fastener hold the nose of the tool against the work piece to depress the contact
safety then pull the trigger to fire a fastener.
Exhaust air:
each time a fastener is driven a blast of air is exhausted from the top front area of the tool, keep
your face clear of this.
Depth control:
check whether the fastener has been driven into the work piece in accordance with
requirements, the driven depth can be controlled by adjusting air pressure.
Always use the lowest possible air pressure for the following reasons,
-
save energy
-
less noise will be produced
-
a reduction in fastener driving tool wear will be achieved
Any defective or improperly functioning tool must be immediately disconnected from the compressed air
supply and passed to a specialist for inspection.
