OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. They should fit with the machine and your
purpose.
2. Functions
• Before making assembly, changing and adjustment for any accessory, disconnect
the tool from the mains supply to avoid any unintentional starting.
• Please always check the mains supply voltage before use! It must correspond with
the rating label on the appliance.
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
a. Install the bit (Fig. 1)
WARNING
!
Always wear sturdy gloves when handling or changing drill and chisel
bits as they can be very sharp.
Fig. 1
• The drill features the SDS plus
system, which enables easy and safe
bit replacement.
• To fit a SDS plus bit, pull back the
locking sleeve and hold it, push and
rotate the bit into the bit holder as
far as it will go, taking care that the
splines on the shaft of the bit locate
properly within the chuck.
• Test for proper location by releasing
the locking sleeve and giving the bit a
sharp pull. If the bit can be removed,
again pull back the locking sleeve,
rotate the bit a fraction of a turn and
re-insert it into the chuck.
• Release the locking sleeve and again
test for proper location. Repeat if
necessary until you are sure that the
bit is properly secured.
Summary of Contents for Z1C-DW-32M3
