Chapter 2
ACCESSORIES
II. Main Parts Fitting
1. Installing Controller
Insert the fixing rod of controller into square tube. Then adjust
controller to position proper to user and rotate the bolt to fix it in
place.
Below the controller and used for charging battery.
Ill. Storage Battery and Charging
1. About Storage Battery
Please do not recharge the battery when it is fully charged.
It is not allowed to fully discharge the battery with proper discharge rate of and no higher
than 80%.
If the battery is not frequently used, please do not charge the battery repeatedly. It is
advisable to charge the battery every two months.
Please charge the battery as soon as after it is used. It is forbidden to store the battery
under low charge condition.
It is prohibited to get the battery in conditions like fire, water, over temperature (45
o
C),
huge vibration, collision or short circuit.
Do not charge the battery for a long time (over 20 hours).
2. About Charging
After application, please carefully check the battery charge volume displayed in LED
(electrical controller display) to determine if charging is needed.
Please use the exclusively-used charger supplied by our company.
How to charge the battery? The two charging pots supplied in this wheelchair could be
used at your discretion.
Insert the output end of charger into the charging pot of electrical controller and the input
end is plugged into municipal AC power socket charging indication light will be on with red
light and orange light respectively.
Please check the charging indication light to determine whether the battery is fully
charged. When the orange light turns to green, it means the charging process is over.
www.ayecogroup.com
Electric wheelchair users do not tire
from use like someone in a manual
wheelchair might after a long
period of use.
DO YOU KNOW?
