By scrolling up or down and then click
OK
to save the selection.
(See Dia-E )For example ,select
1,000 sample data
,the logger will
stop collecting data and power off for saving battery when 1000
data collected completely .
Recording inactivated when selected data is full , and yellow LED
light will not blink to confirm operation is stopped .
SAMPLE RATE :
Select the sampling time ranges from 1 ~43200
seconds. Scroll up for increasing time in seconds or down for
decreasing time in seconds. The datalogger defaults sample rate
is the same as you last setting..
16
FAQ:
If I want to stop logging before completing all sample
points , how should I do ?
Ans
: 1. Downloading by PC to stop logging.
Note: The download operation before completing all sample
points won't work for the logger sample rate to be set
as "1" second.
2. For 8813/14/15 and 8833/34/35, press "start/stop" key for
over 3 seconds could also turn off the logger any time.
START MODES :
(Diagram E):
Schedule
-
Set up
Start Date/Start
Time desired to start logging. The logger
will start when the setting time clock reaches the time you entered.
Make sure the logger date and time are the time you are now .
Magnetic
-
Link with your computer to setup the Magnetic start mode , select
Magnetic
, make sure the logger date and time are the time you are
now , press "
OK
" , enter desired ID , press"
OK
" to confirm the
Magnetic start setting. To start with magnetic, use a strong magnetism
one pass over the middle of the bottom, now LED is flashing .Flashing
times is depend on the time interval of every sample logging.