11
ASSEMBLY INSTRUCTIONS
5
6
5.Put the Glass Beads (Q) around the Burner (C).
6. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only.
Use this heater onl y with a propane vapor withdrawal
supply system. See chapter 5 of the standard for
storage and handling of liquefied petroleum gas,
ANSI/NFPA 58. Y our local library or fire department
should have this b ook.
Storage of an appli ance indoors is permissible only if
the cylinder is dis connected and removed from the
appliance. A cylinder must be stored outdoors in a
well-ventilated are a out of the reach of children. A
disconnected cylinder must have dust caps tightly
installed and must not be stored in a building, garage or
any other enclosed area. The maximum inlet gas supply
pressure: 250 psi, The minimum inlet gas supply
pressure: 5 psi .
The minimum hourly of 10000 Btu is the required input
rating for a heater for automatic operation at ratings less
than full inputrat ing .
The pressure regulator and hose assembly supplied
with the appliance must be used.
The installation m ust conform with local codes, or in the
absence of local codes,with national fuel gas code,
ANSI Z223.1/NFPA54 , natural gas and propane
Installation Code, CSA B149.1, or propane storage and
handling code, B14 9.2.
Standard 20 lb. tank
Put the Burner Cover (A) on the burner,
when the Fire Pit is NOT in use or after use.
Summary of Contents for FS-1212-T-10
Page 1: ...OUTDOOR Model FS 1212 T 10 FIRE PIT TABLE Owner s Manual...
Page 18: ...18...
