16
CARE AND MAINTENANCE
Gas odor with extreme yellow tipping of flame.
Fire pit does NOT reach the desired temperature.
Fire pit glow is excessively uneven.
Fire pit makes popping noises.
Spiders and insects can nest in burner or orifices. This dangerous condition can damage fire pit and
render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may
help clear away smaller particles.
Carbon deposits may create a fire hazard. Clean burner with warm soapy water if
any carbon deposits develop.
Note:
In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.
Frequently check for corroded areas and repair them promptly.
TIP:
Use high-quality automobile wax to help maintain the appearance of
your fire pit. Apply to exterior surfaces only. Do not apply to burner.
Storage
Between uses:
Turn Control Knob OFF.
Disconnect LP source.
Store fire pit upright in an area sheltered from direct contact with inclement weather (such as rain,
sleet, hail, snow, dust and debris).
If desired, cover fire pit to protect exterior surfaces and to help prevent build-up in air passages.
Note:
Wait until fire pit is cool before covering.
During periods of extended inactivity or when transporting:
Turn Control Knob OFF.
Disconnect LP source and move to a secure, well-ventilated location outdoors.
Store fire pit upright in an area sheltered from direct contact with inclement weather (such as rain,
sleet, hail, snow, dust and debris).
If desired, cover fire pit to protect exterior surfaces and to help prevent build-up in air passages.
Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note
: Wait until fire pit is cool before covering.
Service
Only a qualified service person should repair gas passages and associated components.
Caution
: Always allow fire pit to cool before attempting service.
Summary of Contents for FS-1212-T-10
Page 1: ...OUTDOOR Model FS 1212 T 10 FIRE PIT TABLE Owner s Manual...
Page 18: ...18...
