บริษัท เอดีดี เฟอร์เนส จ ำกัด
ADD FURNACE CO.,LTD.
44 ซอยบรมราชชนนี
70 ถนนบรมรำชชนนี แขวงศำลำธรรมสพน์ เขตทวีวัฒนำ กรุงเทพฯ 10170
โทร
: 02-888-3472
โทร
:
ออกแบ
บ
:
08-08-170-170
แฟกซ์
: 02-888-3258
https://www.add-furnace.com E-mail:
sales@add-furnace.com
WARNING
When using combustible gas, install the device upstream of the safety
shut off valve. If air somehow enters the piping, and the sensor makes a spark
due to some cause like a lightning strike when an explosive mixture is
present, an explosion could occur inside the pipe.
On flanged models, do not use the device or installed pipes as a footrest.
Doing so might damage the device or piping, or cause a slip which might
result in injury.
Flanged models are heavy. Dropping them on your feet may cause injury.
The device is intended for use with natural gas and air.
Do not use the device for other types of gases. Use of the gases having an
ignition temperature lower than 365°C may cause an internal pipe explosion.
A heater incorporated in a sensor could act as an ignition source if air has
entered the piping and explosive mixed gas is produced.
Use the analog outputs and alarm contact outputs on the device for
monitoring the gas flow rate of a burner or other equipment. Do not use these
outputs in applications where safety will be impaired when an analog output
abnormality or alarm contact output malfunction occurs.
Before wiring the device, be sure to turn the power OFF. Failure to do so might
cause electric shock.
CAUTION
This device is a precision instrument. Do not drop it nor subject it to shock.
Doing so might damage the device.
Do not peel off the pipe connection port seals until immediately before you
connect the piping. Doing so might allow foreign objects to enter the
connector port and cause defective operation.
On rusty, welding fumes, slag, water droplet, oil mist or dusty piping, install a
filter upstream to prevent foreign matter from entering the device. Foreign
matter may cause faulty operation.
When wiring, take care not to tug on the display. The components inside
might become damaged.
Be sure to use only rated fuses for replacement. Use of a non-rated fuse
prevents the safety circuit from functioning properly.
Be sure to check that the wiring is correct before you turn the power ON.
Incorrect wiring may cause damage or malfunction.
Connect the power supply last. Otherwise touching terminals by mistake may
cause electric shock or damage the device.
Make sure that the load to be connected to terminals does not exceed the
rating indicated in the specifications.
ii
