AB-5702
ACTIVAL, Infilex, and SmartScreen are trademarks of Azbil Corporation in Japan or in other countries.
BACnet is a registered trademark of American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE).
Specifications are subject to change without notice.
Building Systems Company
http://www.azbil.com/
Rev. 5.0 Dec. 2013
AB-5702
(J: AI-5702 Rev. 4.0)
Printed in Japan.
12
Installing the lithium battery of TOT model
Hold and connect the connector of new lithium battery. Follow the steps of
Removing the lithium battery of TOT model
in
reverse to install the new battery. See the step 4) of
Setting (Addressing and Functional Setting)
to attach the switch cover.
Figure 11. Lithium battery installation
Precautions for use
●
Do not install CDGP upside down. (Do not allow the ports for communication wiring to face upwards.)
●
Be sure to provide the remote control transformer for the RRD model using the remote control relay and the remote control
breaker. For providing these devices and the remote control switch, thoroughly read the instructions supplied by their
manufacturers.
●
Do not bind the communication cables (LAN cables) with other cables.
●
Confirm that all wiring connections are correct before turning on CDGP. An input wiring misconnection (wrong +/-
connection) of AI model might cause incorrect input value of another input wiring of the same AI model. (This input value will
be corrected when the misconnection is corrected.)
●
Do not detach the switch cover, located on the lower right of the front face, except when performing the following:
- Turning the rotary switches for addressing.
- Sliding the DIP switch for functional setting. (DIO and DI models)
- Replacing the lithium battery. (TOT model)
Be sure to attach the switch cover after finishing the above.
Battery case
(open)
Lithium battery
Connector
Connect.
Release tab
Switch cover
Attach.
Replacement date label
Write down the date of next replacement
(five years after current replacement)
when you replace the lithium battery.