Copyright © 2006 by AZiO Corp. – www.aziocorp.com
25
Notices
COPYRIGHTS
Copyright © 2006 AZiO Corporation. All rights reserved. No part of this
publication may be reproduced stored in a retrieval system, or transmitted in any
form or by any means, electronic, mechanical, photocopying, recording or
otherwise, without the prior written consent of AZiO Corporation.
TRADEMARKS
The AZiO name and its logo are registered trademarks of AZiO Corporation.
Other trademarks mentioned or appearing in this document are the property of
their respective owners.
CHANGES
The material in this document is for information only and subject to change
without notice. While reasonable efforts have been made in the preparation of
this document to assure its accuracy, AZiO assumes no liability resulting from
errors or omissions in this document, or from the use of the information
contained herein. AZiO reserves the right to make changes or revisions in the
product design or the product manual without reservation and without obligation
to notify any person of such revisions and changes.
FCC Information
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B
Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instruction manual
may cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio TV technician for help.
