Protocol - Modular AC-DSP
V1_version Feb-2011
13
4
MODIFIABLE OPERATING PARAMETERS
The following indicates the operating parameters of the validator that can be modified directly
on the validator through the dipswitches or Azkoyen hardware/software tools
4.1
Modifiable parameters using dip switches.
Using the 4 available dip switches on the validator, it is possible to modify some settings
without using any external tool. The following table shows parameters that may be changed
with the switches as well as the position of the switches.
Parameters
SW1
SW2
SW3
Price of Service
0
0
0
Coins accepted
1
0
0
Time of service
0
1
0
Programming Token 1
1
1
0
Programming Token 2
0
0
1
Wide Tables
1
0
1
Bonus
0
1
1
Table 6. Modifiable parameters using switches.
To programme the parameters with
dipswitches,
follow the steps below:
1.
Place
SW3
,
SW2
and
SW1
dipswitches with the parameter settings to modify
according to table 6.
2.
Put dipswitch SW4 ON. The electromagnet on the acceptance gate will make a short
“click”.
3.
Do the appropriate action to set the parameter (see specific indications in paragraph
4.1.1)
4.
Put dipswitch SW4 OFF. If the programming was correct, the solenoid on the
acceptance gate will make a long “click”. If the programming was not correct, the
solenoid on the acceptance gate will
NOT
“click” and you will have to repeat the
process from the start.
4.1.1
How to programme each parameter correctly.
Service price:
enter the amount of coins you need to reach the price according to
the value of each coin. The programmed price shall be the sum of the values of the
