Protocol - Modular AC-DSP
V1_version Feb-2011
8
There are a series of parameters in this operating mode whose default values are configurable
and modifiable with the Azkoyen tools:
The
duration of the output pulses
.
The
signal edge
of the inhibition signal
.
The
assigning of outputs
.
3.3
Validator AC-DSP in Timer mode.
The operation of the validator in timer mode is characterized by giving an operating time
(power/access) when the programmed price for that time period is reached by introducing the
necessary coins
The pinout of the connector J1 in this operating mode is as follows:
Connector J1 of Output module
Pins
Function
Notes
Pin 1
GND
Pin 2
12-24 Vdc
Minimum: + 10 Vdc; Maximum: +27 Vdc
Pin 6
Input
Inhibition coins/request service
Pins 3, 4,
5,7,8,9 and 10
Output
Available for output of Operating time, Counter,
Warning signal, Credit available
Table 4. Pinout Timer mode
These validators can work in three different modes
Working in continuous mode.
When it reaches (or exceeds) the programmed price, the validator automatically and
continuously gives the time corresponding to the entered price. The value of the
output pin status remains unchanged until the end of the service
If the introduced amount was higher than the price, but insufficient to achieve the
value of another service, the remaining value will be stored.
The output pin is configurable
Input pin 6 works as inhibition in the acceptance of coins. The flank of inhibition is
configurable.
