17
07 - 2009
3.3.2 Types of connectors
There are two options for the type of connector used:
1. AZKOYEN Molex 2x6 way connector
2. Cinch
12
way
connector
The most common connector is of the type Cinch male. The complementary connector is
mounted on the base plate.
A new connector has been developed to facilitate the connection to the machine in those
applications where it used to be necessary to have soldered connections. This connector is a
Molex 2x6 way. This connection has as the advantage that the machine may be wired up with
2x6 way ribbon cable and therefore be connected directly to the base of the hopper without the
need of solder.
1. AZKOYEN Molex 2x6 way connector
The connection from the master to the T3 is made by means of a Molex 2x6 way female
connector located in the base plate of the hopper.
The hopper is connected to the base by means of a 2x6 way Plug & Play connector doted with
a mobile mechanism that means that it adapts to the connector of the position of the hopper
without damaging the connectors.
Figure 11: Base with Azkoyen connector and details of the front and back
Summary of Contents for t3 hopper
Page 40: ...40 07 2009 6 7 8 9...