www.aztectent.com
Step 13:
Lift up one side of the tent off the ground and slide two of the leg pipes
over the corner fi tting and pin into place. Tent Jacks (optional accessory)
are shown to aid in the lifting of the frame. Either using tent jacks, man
power, or another lifting device the frame needs to be supported at
every leg when lifting to prevent undue stress on frame members.
Step 14:
Lift up the other side of the tent and install and pin the leg pipes on the
other two corner fi ttings and middle legs.
Step 15:
Anchor the tent with the included stakes and ropes. The ropes should
be tied around each of the perimeter fi ttings with an overhand slip
knot. The stakes should be driven approximately six (6) feet away from
the bottom of the leg. To achieve proper rope tension, drive each stake
approximately 38” into the ground with a sledge hammer. Tie the rope
to the stake with a clove hitch and continue driving the stake into the
ground until the rope is tight
Summary of Contents for STANDARD FRAME
Page 1: ...STANDARD FRAME PRODUCT MANUAL If YOU can IMAGINE it WE can BUILD it...
Page 27: ...www aztectent com...
Page 43: ......