SAFETY PRECAUTIONS
Please follow the instructions in this manual for correct and safe operation
of the device. Pay special attention to the following warning signs beside
the operation descriptions where applicable.
2
4
DANGER :
This message appears where the operation may potentially cause
severe injury if instructions are not followed correctly.
WARNING :
This message appears where improper operation may cause
serious damage or defect to other objects
.
if instructions are not
followed correctly
CAUTION :
This message appears where improper operation may cause
slight damage to other objects or the human body if instructions
are not followed correctly.
IMPORTANT :
This message appears where the operation may involve risk of
defecting the device itself if not properly conducted.
EU-wide legislation, as implemented in each Member State, requires
that waste electrical and electronic products carrying the mark (left)
must be disposed of separately from normal household waste. This
includes monitors and electrical accessories, such as signal cables
or power cords. When you need to dispose of your display products,
please follow the guidance of your local authority, or ask the shop
where you purchased the product, or if applicable, follow any
agreements made between yourself.
The mark on electrical and electronic products only applies to the
current European Union Member States.
protecting against electric shock for type B equipment
ISO 7000-1641 : Follow operating instructions or consult instructions
IEC 60601-1
:
Applied part classification - Complies with standards
for use
IEC 60417-5009 : STAND-BY
IMPORTANT :
If light curing materials not within the range of
360
-
420
nm (UV Light) and
420
-
490
nm (Blue Light) is used with the device, the material may have
difficulty completely curing or required an extended curing duration.
The device is prescription use only.
Manufacture date
Storage conditions: -20°C to 65°C
Manufacturer
Explanation of Graphical Symbols :
IEC 60417-5031 : Direct current.
Cooling System :
>> This device is designed with a built-in cooling fan which automatically
activateswhenever the device is in use, and continues to run for a few
seconds after the cycle has ended.
>> If the temperature gets exceeds
45
°C, the fan will continue to run until the
internal temperature has cooled down.
>> If the temperature gets exceeds
65
°C, the device will automatically shut off
and the fan will continue to run. Until the internal temperature has cooled
down, the device will be unable to start.
>> Under the premise of not touching the oral tissue, when using the curing
light,switching the treatment area or switching any operation settings, it is
necessary
to cool down for 30 seconds before starting the next curing cycle.
>> If the unit needs to be used for continuous curing, please decrease the
curing time.
Class II equipment
