LogBox-RHT-LCD
Temperature and Humidity Data Logger
0568 0038-01
0141 0315-88 29.11.2021
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
Seite
12
von
18
Technische Änderungen vorbehalten
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
9
L
OG
C
HART
II
S
OFTWARE
9.1
Installing LogChart II
The LogChart II is the software provided with the logger to allow for configuration and data collection. To install the LogChart II, execute the
LC_II_Setup.exe program available on our website. The installation wizard will then guide you throughout the installation process.
9.2
Running LogChart II
Start the program. The main window will appear on the screen, as in
Fig. 3
.
The LogChart II requires a communication port to talk to the logger. Select one and connect the corresponding wand IR-LINK3 to it. Click on the
menu Port. Clicking on the menu Port, all free communication ports available in the computer will be listed. The chosen port will be remembered
next times the LogChart II is initiated.
When the selected port is successfully opened, the LogChart II initial screen is opened, enabling the buttons below
In case the user wants to stop the process while data logging is running, the button “Stop” must be pressed
9.3
Configuring the Logger
Make sure the IR-LINK3 wand is connected to the PC port selected. The interface must be pointed towards the logger communication window
(see Figure below) at a distance of about 15 cm.
Click the button
to start the communication between the logger and the software; the Parameters Configuration window is then
displayed (Fig. 6), showing the current configuration and information about the logger. New configuration parameters defining the operation
mode for a new application can be entered. The user can also obtain general information about the device.
The fields of the configuration window are described below
Figure 20
LogChart Main Window
Figure 21
