LogBox-RHT-LCD
Temperature and Humidity Data Logger
0568 0038-01
0141 0315-88 29.11.2021
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
Seite
5
von
18
Technische Änderungen vorbehalten
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
Figure 8
IR COMM Sreens
Figure 9
Display Updating Screen
5.1.3
Min / Max Indication
It indicates the minimum and maximum value during the acquisitions. The Channel for which the values are just displayed is indicated on the
screen on the left side as CH1 or CH2
5.1.4
Communication Screen IR-COM
It sets IR communication to automatic or to manual:
•
In the automatic mode (
AUT
), communication will be always active. For communicating, just direct the
IrLink3
interface and use
NXperience or LogChart II software. It always stays in this mode after reset.
•
In the manual mode (MAN) communication will be active 20 seconds, after pressing the button. During this time, a communication
shall be initiated for keeping the IR Communication active.
5.1.5
Display Updating Interval Screen (DISP)
It sets the reading time of the sensor for the display updating. When selected by
LO6
, it performs the sensor reading and the display updating,
according to the interval set for acquisition.
When selected by 10 S, 30 S or 60 S it performs sensor reading for display updating every 10, 30 or 60 seconds. In this mode if the acquisition
interval is shorter than the time set in the screen
DISP
, display will be updated according to the acquisition interval
6
B
ATTERY
A
UTONOMY
The estimated battery autonomy is above 200 days. This autonomy is directly related to the register using mode. The shorter is the interval of
the sensor reading, the smaller will be the autonomy, and it can last only 30 days, in the worst case.
Figure 7 Min Max Indication Screen
