INSTRUCTION MANUAL
TagTemp
Temperature Data Logger
Technical changes reserved
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
0141 0315-84 22.06.2016
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
9 / 14
In this dialog box the user can define the logger operation mode and also obtains general information about the device. The different
Fields and their meaning are listed in the following:
Title
In this field, the user identifies the logger by assigning it a name.
General
information
Area with information about the logger, such as Model, Serial Number, Logger Date/Time,
PC Date/Time, firmware version, memory capacity and number of acquisitions stored in
memory, etc. In this field, time is constantly updated while the communication between
logger and computer is taking place
Acquisition
Register card where a series of parameters that define the acquisition process are
determined.
Period
Defines the interval between readings: The minimum interval is one (1) second and the
maximum is eighteen (18) hours.
Note: When the type of value logged is maximum or minimum values (see
Value
), the
minimum interval possible is 10 seconds.
Daily Operations
Here the user defines the time at which daily logs will take place
Estimated time
This field informs the user how long it will take to fill totally the memory, under the
conditions set up during configuration.
Start of readings
Readings can be started in one of five different modes
Immediately
Measurement starts as soon as set up is ready and sent (OK) to the logger.
Start via Palm
Measurement starts with a command sent via a PDA, which runs the software Log Chart
Palm-OS.
Date
Readings start at a predefined date and time.
Via Start/ Stop
Measurement
starts and ends by pressing the Start/Stop button, in the frontal part of the
logger, for two seconds.
Setpoint
Acquisition starts when a
temperature
setpoint is reached. In this option, the setpoint
value is defined in the Channels field, where the Alarm parameter is replaced by setpoint.
Stop loggings
Defines the event that initiates the end of measurement. The following options are
possible.
Full Memory
Measurement is stopped when the memory is full (16 000 values).
