TagTemp USB Temperature Logger
0568 0037-01
0141 0315-92 28.11.2022
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
Seite
10
von
14
Technische Änderungen vorbehalten
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
F
IGURE
14
Channel Configuration
6.
Channels:
Displays other parameters related to temperature measurement
•
Unit
: Defines the unit of the value measured: ºC or ºF for channel 1 (temperature).
•
Value
: It defines how the value measured will be registered. Options are:
o
Instantaneous
: The value logged will be exactly the value measured at each interval defined. Measurement is taken at the
end of the defined interval. The minimum interval between measurements is 5 seconds.
o
Average
: The registered value will be the average of 10 measurements made on logging interval. The minimum time
between each record is 50 seconds.
o
Maximum
: The value logged will be the maximum value found within 10 consecutive measurements taken within a
predefined interval. The minimum interval between measurements is 50 seconds.
o
Minimum
: The value logged will be the minimum value found within 10 consecutive measurements taken within a
predefined interval. The minimum interval between measurements is 50 seconds.
•
Offset
: Makes possible to correct the value logged adding or subtracting a constant (known) error value
•
Alarm
: Defines limit values that, when exceeded, characterize an alarm condition. Alarm events are informed to the user through a
flashing mode of the Alarm Indicator.
After filling all the fields, select OK and the settings will be sent to the device.
8.4
Stop / Pause / Resume Buttons
These buttons will be enabled once the device is fully configured.
The
Stop
button allows stop logs permanently, so that the device will only register again after a new configuration by the
user
The
Pause
button action sends the appropriate command, depending on the current logging status: If the logs are In
progress, pressing this button, it will be send a command to
Pause
the logs
When the Logging has been “paused” via pressing the
Pause
Button, the latter will mutate to a “
Resume
” Button.
Pressing this button will send a command to the device to resume the that were interrupted by the Pause command
without erasing the previous registers of the device memory, using the same parameter settings previously configured
After this the button mutates again to reflect the “
Pause
” function
8.5
Downloading Data
Downloaded data are send from device to PC. Data can be downloaded any time at the end of the acquisition process or while they are being
acquired. If data downloaded takes place during the acquisition process, the process will not be interrupted, following the device configuration.
Data download is accomplished by clicking the button Download Data
. During data transfer, a status bar indicates remaining data to be
transferred. Data downloading time is proportional to the number of readings logged
