TagTemp USB Temperature Logger
0568 0037-01
0141 0315-92 28.11.2022
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
Seite
4
von
14
Technische Änderungen vorbehalten
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
5
O
PERATION
To operate the device, you must install NXperience software or LogChart II software on a PC, as instructed in the SOFTWARE NXPERIENCE
and SOFTWARE LOGCHART II chapters of this manual. The communication between device and PC must be performed using a USB
connector.
The configuration that defines the operation mode of the device must be previously created in the NXperience or LogChart II software. Each
parameter must be defined, and the consequences must be observed.
The device starts and stops registering as defined in the settings
6
D
EVICE
C
ONFIGURATION
To perform a configuration, the device must be connected to the USB port of the PC.
7
NX
PERIENCE
S
OFTWARE
7.1
Installation
NXperience
software allows you to explore all the features of the device by communicating through its USB interface. It is also a complete tool
to perform the analysis of the data logged by
TagTemp-USB
.
To install
NXperience
, just execute the
NXperienceSetup.exe
file, available from our website.
7.2
Running NXperience
When you open
NXperience
, the main window is displayed as shown in Fig 3
You should click Configure, and then click Read Device
To mitigate problems, insert or remove the USB cable
carefully.
If you find it difficult to connect, make sure that the cable is
properly seated. No use of force is required.
F
IGURE
2
Communication via USB cable
F
IGURE
3
NXperience main Window
