AirborneM2M™ User Guide
58
Step
Description
Optional
Press
Restart
[Button]
Restarts the device. After the device as rebooted, it will attempt to
authenticate to the configured network. As long as the network is
in range, the wireless interface will connect.
Once authenticated, the network it is possible for a TCP/IP
connection to be made on the Telnet port.
To establish a data tunnel and gain access to the serial data from the WLAN or Ethernet interface, follow
the steps in Table 32.
Table 32 - Data Tunnel using Telnet Port
Step
Description
Open TCP socket to device
Using the WLAN IP Address and configured telnet port number.
Authenticate with device
auth dpac dpac
Any user level above L5 can authenticate with the unit.
Device responds
OK
Open data tunnel to serial port
pass-x
Where
x
can be
p1
,
p2
or
any.
p1
or
p2
binds to the indicated serial port, as long as the serial port
is in listen mode and does not already have a data tunnel open.
any
binds to the first serial port which is in listen mode and does not
already have a data tunnel open.
