F L U S H I N G T H E S Y S T E M
A. To fl ush the down-line plumbing, complete the following steps:
A.
Install all cartridges.
B.
Slowly turn the water back on at the ball valve on the left-hand (inlet) side of the single stage
housing. Check for leaks.
C.
Open the down line faucets one at a time, and let the water run for a minimum of four (4) minutes
per faucet.
S T O R A G E
For brief periods of non-use (days), fl ush the entire system thoroughly (4 – 5 minutes) before and
after periods of storage and before drawing water for consumption.
Do not allow the system to freeze. Water contained within the system will expand and damage the
system and its capacity to purify any water. For longer periods of non-use (weeks or months), the
following steps must be taken:
A.
Empty water from the entire system.
B.
Remove cartridges from their housings.
C.
Clean cartridge housings thoroughly.
D.
Clean and air-dry exterior of the cartridges.
E.
Record activity in a service log.
F.
Place cartridges in clean plastic bags once dry.
G.
Remember to replace all cartridges in the proper order and fl ush the system for 5 – 7 minutes
when reactivating the system.
BDC6000BB
Certifi ed Nanotechnology Whole House Purifi cation System
10
Hel neu st 57
