J
Your AU620/AU820 comes from the factory ready for conventional (mono)
use. This means a single speaker will handle a single channel of
information, such as what is required for surround channel use.
Using the AU620 or AU820 as a “Single Point Stereo” Speaker
DRAWING 16
DRAWING 17
Using two AU620 or AU820 speakers for
stereo (conventional / surround use)
If you are going to use your AU620/AU820
speaker for surround channel duties, leave the
jumpers in the configuration (see drawing 16).
The AU620 and AU820 speakers feature two
sets of push-to-connect terminals. You may
connect the speaker wires to either set of
terminals but it is essential that the correct
polarity of the connections to your amplifier is
maintained.
If you want to use the AU620 and AU820 as a
single-point stereo speaker (where the left and
right channels are handled by the single unit),
then move the jumpers to the position shown
left. Set the Bipole/Dipole switch to the Bipole
position so the tweeter is in phase with the
woofer.
Connect the speaker wires for one channel to
one set of terminals, and the speaker wire for
the other channel to the other set to terminals.
If the sound form the speaker lacks definition, it
is likely the polarity is incorrect. It does not
matter which speaker terminals are connected
to the left or right channel on your amplifier, but
correct polarity is critical (see drawing 18 and
19).
DRAWING 18
Using two AU620 or AU820 speakers for
single point stereo
DRAWING 19
8
