RELEASE DATE
7-13-16
REFERENCE
NUMBER
INS-1382-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • info@bklighting.com
B-K LIGHTING
3. Wipe inside of housing where HydroLock® plate
will sit clean of debris before inserting patented
HydroLock® plate on to junction box. Align
HydroLock® plate with pins in housing and seat
it firmly in place.
Installation
5. Connect ballast assembly to Patented
HydroLock
®
Barrier plate with quick disconnect.
PROJECT:
TYPE:
WIRING DIAGRAM
COM
GROUND
LINE
COM
GROUND
LINE
HydroLock Plat
e
1. Remove temporary cover.
2. Make watertight connections using waterproof
wire connectors (provided) to leads on the
bottom of Patented HydroLock® Barrier Plate
Assembly.
See wiring diagram.
4. Turn HydroLock®
Barrier Plate clockwise ¼” to
lock.
Patented
HydroLock® Barrier Plate must be
completely seated to ensure proper seal or
water may intrude. This step must be done
as stated or you will void your warranty.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
CO
2
SERIES
Integral - Standard/Offset Metal Halide (ES16)
Ballast Installation Instructions
6. Lower ballast assembly into CO2 housing.
1
2
7. Line up ballast plate to posts inside CO2 housing
with screws as shown with white arrows above.
Rotate ballast plate to lock into position.
8. Tighten the Phillips screws to secure plate to
housing.
