POWER
DIM
INPUT
VOLUME
CS2
AC Power Cable
Remote Control RC1
DIGM optical waveguide
Owner's Manual
Please keep the packing for eventual later transportation.
In classical integrated amplifier mode
by default all inputs are operating
traditionally and are compatible to any
source component.
In case of a B.M.C. component like
BDCD or MCCI more sound quality is
achieved by using our “current
injection” (CI) input mode for balanced
inputs.
Select either XLR1 or XLR2, then again
press the input key and hold it for about
5 seconds. The XLR-CI will light up and
this configuration is stored for the
individual input.
Do the same procedure again to disable
CI for the selected XLR input.
Note: Never use CI inputs for non-
B.M.C. components.
In most cases the
sound quality will decrease due to
incompatibility and in some cases even
a damage of the source unit might
occur.
Front Panel Functions
Content of Packing
Advanced Functions
➀
POWER
Turn for powering ON and OFF the unit
➁
DIM
To dim the lights of this window
➂
DIGM Display
Shows the selected DIGM Gain (00-66)
➃
Power Meter
Shows actual power in WATT (at 4 Ohm)
Level indicator in dB, reference level 0 dB is 1 W
➄
INPUT
Toggle switch to select the INPUT
The selected INPUT is lit up
➅
VOLUME DIGM
DIGM = Discrete Intelligent Gain Management
The amplifier's gain can be adjusted in precise 1dB increments
The selected value (00 - 66) will be displayed
If an OPTO CONTROL connection is active, DIGM is controlled by the DAC
