Installation Instructions
JAMISON DOOR COMPANY
28
H4494002 REV B
18.
PROGRAMMING RADIO CONTROL RECEIVER
Unscrew antenna and remove cover from receiver as shown on previous page.
Reinstall antenna onto receiver without the cover.
Push button in receiver until LED #1 comes on.
Push and hold button on remote control until LED #2 and #3 blinks on the receiver.
Release button. (For the next 13 seconds you can program additional remote controls, by pushing the
desired button and watching LED #2 and #3 blink.)
After your last remote, push the button on the receiver and LED#1 will go out.
Deprogramming a remote
Push the button o
n the receiver for approximately 3 seconds until the LED’s #1,2 and 3 begins to blink.
P
ress and hold the button on the remote until the LED’s stay on solid.
Push the button o
n the receiver, LED’s go out.
For completely clearing the receiver, push the button in the receiver for about 6 seconds until LED
’s #1,2 and
3 come on solid.
Release the button.
If the memory is full during the storage phase the four LEDs will switch off and on in sequence and then
switch off. Completely clear the receiver and start over.
Summary of Contents for ThermicRoll
Page 2: ...Installation Instructions JAMISON DOOR COMPANY 2 H4494002 REV B...
Page 14: ...Installation Instructions JAMISON DOOR COMPANY 14 H4494002 REV B Pin Set Screw Pin Set Screw...
Page 27: ...Installation Instructions JAMISON DOOR COMPANY 27 H4494002 REV B 17 RADIO CONTROL RECEIVER...
Page 38: ...Installation Instructions JAMISON DOOR COMPANY 38 H4494002 REV B Notes...
