■
The unit is equipped with a special protection feature: It will stop operating with all indicating
lights off for 30mins, after every 8 hours’ non-stop operation. 30mins later the unit resume
operating automatically. Press Power Button can awake the unit at any time.
■
Once after the unit runs for 1 minute without receiving any further operation instructions, all
indicating lights and the Fan Speed Display will be shown 50% of brightness, while other
functions remained. To wake up, press any button on the control panel.
ATTENTION
12
11
Always disconnect the power supply of the unit before any maintenance
or care process is carried out (except replacing filters).
(Otherwise the
unit might still be running and could cause an electrical shock or injury)
ATTENTION
■ Please follow the instructions to clean the unit with detergent cloth.
■ During maintenance, do not touch the disassembled parts.
(Otherwise could cause stumble or parts damaged.)
■ Do not operate the unit if Filters have not been installed, since this could cause irreversible
damage to the unit.
■ If the HEPA Filter is not replaced periodically as indicated in instructions, it may seriously
affect the efficiency of the NCCO Reactor.
Cleaning Instructions
Cleaning Air Inlet And Outlet
Clean the air inlet and outlet with a soft brush or vacuum
cleaner.
2
Cleaning Pre-filter
Pre-filter can be cleaned with water.
Make sure it is dried out before usage.
3
4
■ Do not rinse or soak HEPA Filter or NCCO
Reactor with water.
WARNING
Cleaning Unit Body
Use dry and soft cloth to clean the unit.
■ Damp cloth can be used to clean the surface of the unit.
Do not use abrasive materials.
ATTENTION
10. Auto Mode* (Auto Mode: ON; Manual Mode: OFF)
First, long press the button for 5 seconds to enter into Auto Mode, where Auto Icon flashes
quickly. Then, press the button again, where flashes slowly to indicate user shall connect the
unit with External Device. Next, press the RF Connecting Button at the External Device. If the
connection is successful, the will be illuminated steadily. If the unit did not receive the connecting
order, it will automatically exit Auto Mode.
(1)If user wishes to change Auto Mode into Manual Mode, when the unit has been woken up
and not in Eco Mode,user can press the Air Speed Increase / Reduce Button to enter into
Manual Mode (The air speed will be increased / reduced simultaneously) or long press the
Eco Mode Button for 5 seconds. At that time, is extinguished and the unit enters into
Manual Mode. User is able to control the unit via Control Panel.
(2)When the unit is connecting with External Device, long press the Eco Mode Button for 5
seconds to enter into Auto Mode.
(3)When the connection between unit and External Device has been disconnected (e.g. the
External Device automatically turns off due to the low power supply), user shall long press
the Eco Mode Button for 5 seconds to exit Auto Mode.
Operating Instructions
Cleaning Instructions
Care & Maintenance
WARNING
1
(*The following function will be activated only after the unit operated with our Air Quality Monitor.)
Getting Started
