2. AIR SPEED MODE
1. ON / OFF
6
7
1. Please carefully read and retain the operation manual for future reference.
2. Remove all packaging materials, wipe all removable parts and grooves by a soft and dry cloth, then reassemble
all these parts.
3. Place the unit at a dry and even place. Keep the unit at least 15cm away from wall or surrounding objects for
normal operation.
4. Check power socket and all external power cords to meet operation requirements. Make sure the unit has been
connected with power supply before operation.
5. The unit is installed with inductor to induce filters' location. If the filters have not been properly installed, the
unit won' t operate.
6. When first switched on there will be warm air. This is perfectly normal and is due to special manufacturing
technique of the NCCO Reactor.
Setup
Before Startup
For the first-time operation of the unit:
Notice
■
Please press filters with force for proper installation.
Setup
Operation Instructions
Control Panel Buttons：
ON / OFF Button
Air Speed
Reduce Button
Display
Screen
Air Speed
Increase Button
Eco Mode Button
Before installing filters, please remove all packaging
material.
Simultaneously press the two buckles to open
back cover.
① Open Back Cover
② Remove Filter Packaging Material
③ Install Filters
Install NCCO Reactor, HEPA Filter and Pre-filter in
sequence into the upper HEPA Filter Frame. The
process of filters installation at the lower Frame
is the same with the process at the upper Frame.
3.1
Clicking sound should be heard indicating
successful filters installation.
3.2
After installing all filters, put the Frames into unit
and close the back cover.
3.3
Installation Steps
ON: Crystal ring should be heard indicating Power On after the unit has been connected with power supply. User
shall press ON / OFF Button to turn on unit, where indicators at control panel will be extinguished 1minute after
there is no further operation control. Press any button to wake up control panel for further operation .
OFF: Press ON / OFF Button again to turn off unit.
Increase Speed: Press the Air Speed Increase Button right to the Display Screen to increase air speed.
Reduce Speed: Press the Air Speed Reduce Button left to the Display Screen to reduce air speed.
Increase Speed
Reduce Speed
3. SS MODE
When air speed is at 10, simultaneously press Air Speed Increase Button and Air Speed Reduce Button to enter into
SS Mode.
It is recommended to select SS mode to treat a seriously contaminated environment at a short time.
Press Air Speed Reduce Button or press ON / OFF Button to turn off unit and then turn on unit again for turning
back to Air Speed Mode with the default air speed at 10.
