Position the unit at the back of car headrest
using the securing ribbon.
Plug in DC power jack into power
port in base of unit.
Note
Note
Operating Instructions
One can connect to a power supply using the following methods
：
8
9
Operating Instructions
Getting Started
Getting Started
When the unit is first turned on (activated), there will be a slight mineral smell. This is perfectly
normal and is due to special manufacturing technique of the NCCO Reactor.
The smell is harmless and will disappear after a period of time operating the unit.
Using internal battery
– Just
press the ON/OFF Button and
the unit will start using its
rechargeable lithium battery
.
Remove base plate from underneath
unit. Remove 4 screws holding ribbon
securing plates. Place and locate both
free ends of ribbon and then screw back
securing plates. Replace base plate.
Using USB power cord
– Insert USB
connector into supplied power plug and
connect to appropriate socket. Insert pin
end of plug into the power port of main
unit. This is located underneath the unit.
You can adjust ribbon tension by
moving ribbon within the clip
buckle.
①
①
②
②
③
③
④
■
■
■
■
If the filter set is not installed into the unit, a “DiDiDi” alarm will sound. Please ensure that the
filters are properly installed before turning on the unit.
If using the unit in a mobile environment, please ensure that the unit is firmly fixed so that it does
not ‘waggle’ or loosen when in motion.
If using the unit in a car, please follow the relevant country laws and regulations such as not
placing free standing objects on the car centre console.
■
Please check and ensure that the car power supply is correct. The power input of this unit
is DC 5V 2A.
■
Before operating unit in car, please make sure that the power supply has been disconnected
and lift up unit carefully.
■
Please check and ensure that the car power supply is correct. The power input of this unit
is DC5V 2A.
Using USB power source (car)
– Insert USB connector into car USB port which will
use charging power from vehicle.
(*Please ensure that ribbon has been tightened to
prevent unit from waggling.)
