Mixing- and preparation table Painty
Page 2
technical changes any time for continuous development and improvement of our products. Such
changes, mistakes and misprints do not constitute a claim for damages. Only original spare parts and
accessories are to be used. The manufacturer and / or supplier is not responsible for damages caused
by ignoring the instructions in this operating manual. Warranty and liability conditions of the manu-
facturers and / or supplier sales and delivery terms are not extended by the above notes.
B-TEC warrants its products to be free from defects in materials and workmanship, for a period of 24
months on a one shift basis. In case of exceptional usage such as multiple-shift operation, the statutory
warranty is shortened to 12 months (two-shift operation) or 8 months (three-shift operation). The
period starts from the date the machine is shipped from the factory. The guarantee expires prema-
turely if the customer or a third party undertakes inappropriate modifications or repairs or if the cus-
tomer, in case of a defect, does not immediately take all appropriate steps to mitigate the damage and
give the supplier the possibility of remedying such defect.
1.4.
Intended Use
This mixing- and preparation table may only be used for its intended purpose. It is
not intended for other purposes than the following terms. The manufacturer/sup-
plier is not liable for any damages resulting from improper use.
The working tables Painty are mixing- and preparation tables for paints and solvents.
This product is for commercial use only, but not for continuous operation (e.g. serial production).
This product does not have any ignition source and is therefore not subject to ATEX-Directive
2014/34/EU. Operation in an ex-zone (e.g. zone 1) is therefore possible.
Improper use of the product can endanger the health of the operator and of others and cause damage
to the product itself or to other objects. Any other use of the product must be agreed and approved
with the manufacturer in advance.
1.5.
Requirements to be the Operator
The product may only be used by competent personnel who, by virtue of their training, knowledge or
experience, ensure proper handling and are aware of the dangers (for example, by reading the oper-
ating manual).
2.
Safety Requirements
2.1.
General Safety
The product is built according to the state of the technology and can be operated safely. However, this
does not mean that the consequences of all operational failures are protected by technical measures.
Dangers can arise from this product if it is used improperly or incorrectly. However, additional organi-
sational measures have to be taken into account for certain workflows, such as the removal of residual
paint from the gun.
•
Read and follow the operating instructions for the product as well as the safety instructions
before commissioning.
•
Always keep the manual available in the immediate vicinity of the product.
