9
The Falcon / The Osprey
Speaker impedance 2 Ohm ~ 8 Ohm
will reach thermal at a faster rate & will eventually go into protect.
Impedance load under 2 ohm is not warranted in strapped mode!
Strapped control panel setting / speaker wiring
step 1.
Run the
positive (+)
speaker cable from the
master
positive terminal (+)
of the subwoofer.
step 2.
Run the
positive (+)
speaker cable from the
slave
negative terminal (-)
of the subwoofer.
Step 3.
negative
speaker output on
master
to
negative
speaker output on
slave
Step 1.
Connect RCA from Head Unit / output source into
master
If only one output is available, then use a Y-split to connect both L & R.
Step 2.
Locate the Master / Slave switch on the right side of the control panel on the
Master
Set the switch to
Master
position.
step 3.
Connect a single RCA from the
RCA OUT
on the
master
Step 4.
Locate the Master / Slave switch on the right side of the control panel on the
Slave
Set the switch to
Slave
position.
Step 5.
Connect the single RCA cable from the
Master
Rca out
to the
slave
RCA IN
.
strapped speaker connection
