REM ( REMOTE )
Connect to sw12V with trigger from head unit.
SPEAKER OUTPUTS
Amplifier connection to loudspeakers.
Minimum speaker cable is 12 gauge.
Mono
minimum impedance is 1 ohm if used as
a single unit.
Mono
in linked mode offers stable opearation to
a minimum of 2 ohms.
Quattro
minimum impedance is 2ohms stereo or
4 ohms mono
GND ( GROUND CONNECTION )
For connection to the chassis' ground.
For optimum performance 0 gauge cable is
recommended.
+12V ( POWER CONNECTION )
For connection to the positive terminal of the
battery (+12). For optimum performance
0 gauge cable is recommended.
3-3.
Mono & Quattro
CONTROL & CONNECTION
4. INSTALLATION
If you chose to install the
B2
series by yourself, please read the owners' manual carefully.
Before you start your installation, please take all steps into consideration. Otherwise, please go to
www.b2-audio.com for authorized distributors or contact us directly for support.
4-1. MOUNTING PREPARATION
Disconnect the negative ( ) battery cable before mounting
B2
series or making any connections.
Check the battery and alternator ground ( ) connections.
Make sure they are properly connected and free of corrosion. Before selecting a mounting location
for the amplifier, please take cooling and safety into consideration.
4-2. MOUNTING PREPARATION
B2
amplifiers have been designed with a good heat radiation heatsink to avoid excessive heat
from the amplifier circuitry. For optimum heat radiation performance, it is recommended to
find a mounting location that allows for vertical installation of the heat sink fins.
HIGH PASS FILTER ( 50Hz ~ 1KHz @ 12dB/Oct )
Adjusts the cut off point for the high pass filter.
The wide frequency range allows for "Active" speaker
operation.
CROSSOVER SELECTOR
Configuration of the filter mode. HPF/FULL/LPF.
LOW PASS FILTER ( 30Hz ~ 300Hz @ 12dB/Oct )
Adjusts the cut off point for the low pass filter.
REMOTE LEVEL CONTROL PORT
Connection of external level control.
3
