b4 Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 QUESTIONS?
Info@b4Adventure.com · www.b4adventure.com 303-339-0482 - DC:080818
7
Figure 3
CORRECT CABLE WRAP - TEAR DROP
INCORRECT - TOO TIGHT!
TREE/
POLE
TREE/
POLE
{
U-Clamp Distance
1 1/2 times tree Diameter
Example: Tree Diameter = 14 In., closest U-Clamp
after final tightening should be 21 In. from the tree
U-shape
thread
U-Clamp
Washer
Thread cover
cap
Third installed
U-Clamp
First installed
U-Clamp
Second installed
U-Clamp
3 In. between bolts
Place thread cover caps on each exposed thread
Course end
of cable
on bottom
• Use your tightening tool to make sure everything is secure
4. TIGHTENING ZIPLINE
• Using the turnbuckle to tighten - inspect your initial installation work carefully and thoroughly. The
zipline cable can hold weight many times that of most riders. The loops, u-clamps and attachment trees
are the most likely to fail if not assembled correctly, and therefore should be inspected extra carefully
and often.
• Tune the zipline by twisting the center section of the turnbuckle to tighten.
• Tighten the line until it appears to be nearly level or straight. DO NOT OVER-TIGHTEN
•you can now remove your six small nails used to hold the cables in position during installation.