IS-033
___________________________________________________________________________
_______________________________________________________________________________________
Baader Ísland ehf, Hafnarbraut 25, Kopavogur, Iceland Tel: +354 520 6900 Fax: +354 520 6911
lager@baader.is / www.baader.is
37
Page 37
Tension of the knife drive belt
Prior to working on the machine switch the main electrical switch to the
0
position and lock it. Failure to comply may result in serious personal injury or
death.
Loosen, do not remove, four hexagon
head bolts (fig. 27 item 1).
Adjust the tension off the toothed belt
(fig. 27 item 2) by lifting the motor plate
(fig. 27 item 3) up or down in the slots.
The correct tension of the toothed belt
should allow approximately 20mm (3/4")
of movement in the middle of the belt.
When complete re-tighten the four
hexagon head bolts.
Fig 27
1
2
3
