4.5.25
Connect two electromagnets to
the
switching cabinet.
Two wires from each electromagnet are to be laid separately in le� and right side beam, and connected at the rear
end of
the
le� side beam to
the
spring wire. The other end of spring wire is to be connected to wire from
switching cabinet, and fixed by rubber sleeve steel cable clamp on appropriate posi�on on concrete column or
rear wall, where
it
is closed to the lower pla�orm and at half of li�ing height above bo�om of founda�on pit.
4.5.26
Middle retaining brackets on both le�
and right post are to be fixed by anchor bolts
onto side walls of founda�on pit. Holes for
fixing anchor bolts are to be drilled with
100mm depth by 16mm percussion bit.
(29) Fixing middle retaining brackets
(28) Electromagnet wiring route
23
P
it
Lift
Installation
Summary of Contents for Starke 2121
Page 1: ...User Manual for Pit Lift ...
