TROUBLESHOOTING
At power up, the digital display does not light up
Make sure the power cable is properly connected to the machine
and to a mains socket.
Press the "cycle start" button:
- if the pulling arm moves, call your BABOLAT After-Sales
Service Centre,
- if the pulling arm does not move, check the fuses and replace
them if necessary (see paragraph "Changing voltage or
fuses").
At power up, the digital display lights up but the pulling arm does not move
after the "cycle start" button is pressed
Turn off the machine, wait 30 seconds and turn it back on.
If the problem continues, go to the "check" menu (see paragraph
"Using the control panel"), note down the values displayed and
the serial number of the machine, then call your BABOLAT After-
Sales Service Centre.
During the stringing process, the clamp-holder malfunctions or does not
unlock
Call your BABOLAT After-Sales Service Centre and if the problem
cannot be solved you will need to replace the circular turntable
(see paragraph "Replacing the circular turntable").
♦
Replacing the circular turntable
The turntable is fixed by 3 screws placed at 120°. The screws can be reached through the
hole, intended for this purpose, under the machine.
Turn the circular turntable by hand to position the posts perpendicular to the line of the
pulling head, with the "racket throat" positioning symbol on the side nearest to you.
Loosen the first screw using the size-6 Allen key: it will remain captive.
Rotate the turntable clockwise by 120°, loosen the second screw and do the same for
the third.
26
