33
4. Rotate the seat by pulling the rotation system
(K)
until you have
positioned the seat in rearward-facing position.
5. Make sure that the arms of the ISOFIX system
(Q)
are fully extended.
CAUTION! Advance to the next step once you have deployed the ISOFIX
arms fully, and the indicator for the ISOFIX arms release button appears red
(fig. 4.2).
6. Place the safety seat on the vehicle seat.
7. Hold the safety seat in place with both hands and insert the two arms
of the ISOFIX system
(Q)
into the vehicle’s anchoring points until
the locking arms click into place on both sides. The red indicator will
change to green on both sides (fig. 4.3 and 4.4).
8. Shake the safety seat to check that it has been anchored correctly to
your car’s ISOFIX points.
9. Push the safety seat against the back of the vehicle seat (fig. 4.4).
10. Press the support leg adjuster button
(U)
as indicated in fig. 4.6 to
deploy the support leg
(J)
until it is firmly supported on the floor
(fig. 4.7). The support leg indicator
(I)
will change from red to green
(fig. 4.8).
11. Pull the turning lever
(K)
and, without releasing it, rotate the safety
seat until it is in the intermediate position; this will make it easier for
you to put your baby in the safety seat (fig. 4.9 and 4.10).
CAUTION! Before each journey, make sure that the rotation system has been
anchored correctly. Please also remember that the intermediate position
is only there to help you put your baby in the safety seat; do not, under any
circumstances, start your journey with the safety seat in this position.
12. Loosen the harness by following the steps in Point 3.2 (fig 4.11).
13. Place the harness in slot A, if your baby weighs less than 9 kg (fig 4.12).
14. Unbuckle the harness
(M)
by pressing the red button and open
the harness straps so that you can put your baby in the safety seat
(fig. 4.13 and 4.14).
15. Put your baby in the safety seat (fig 4.15) and put the harness on him/her.
16. Join the buckles and insert them into the harness until you hear a
click; this indicates that the safety seat has been secured properly
(fig. 4.16). Adjust the harness so that the shoulder straps
(E)
are at the
same level as the baby’s shoulders (fig. 4.17).
Summary of Contents for TEKIE CLASSIC
