57
VEHICLE INFORMATION
1” (2.5 cm)
Sliding Latch Plate and ALR Retractor
A latchplate that slides freely on the belt webbing
and cannot, by itself, hold the belt snug around a
car seat.
Slowly pull the shoulder belt all the way out.
Route
the vehicle seat belt through the proper belt path
and buckle it in. Then, as you pull the vehicle seat
belt tight, feed all the slack back into the retractor.
Grab the sides of the seat at the belt path and slide
the seat side-to-side and front-to-back. The seat
should not move more than 1” (2
.
5 cm).
Sliding Latch Plate and ELR Retractor
A latchplate that slides freely on the belt webbing
and cannot, by itself, hold the belt snug around a
car seat.
With this retractor, you will need to use the locking
clip to lock the vehicle seat belt.
Call us at 1-800-241-1848 to order a locking clip.
Route the vehicle seat belt through the proper belt
path and buckle it in. Pull the vehicle seat belt tight.
While pushing down on seat, pinch the two straps
together behind the buckle tongue. Unbuckle the
belt without allowing it to slip.
Attach locking clip to lap and shoulder belts as
shown.
Rebuckle belt. Check that lap belt does not move
by pulling hard. If belt loosens or lengthens, repeat
procedure.