Baby Jogger city turn Quick Start Manual Download

Page: 4 / 4

INSTALLATION

CHECKLIST

See page 21 in the Installation Manual for complete installation instructions

READ YOUR MANUAL.

Always read your car seat manual prior to installing your car seat. Your car seat

manufacturer should be your primary resource for information regarding your car seat.

INSTALLATION SHOULD BE TIGHT.

Car seats should not move more than 1” (2.5 cm) at the belt path.

CHECK THE LEVEL INDICATOR IN REAR-FACING MODE.

PLACE CHEST CLIP AT ARMPIT LEVEL.

Not too high or too low.

CHECK HARNESS HEIGHT.

REAR-FACING:

Harness straps should be at or below the child’s shoulders.

FORWARD-FACING:

Harness straps should be at or above the child’s shoulders.

PERFORM THE PINCH TEST IN THE SHOULDER AREA TO MAKE SURE

THE HARNESS IS TIGHT ENOUGH.

It is important that the harness is snug against your child’s body.

CHECK INSTALLATION OFTEN.

Regularly inspect your seat’s installation to ensure it is still tight and secure.

Summary of Contents for city turn

Page 1: ...T S GET STARTED Please review this guide carefully prior to installation for tips tricks and a map to your new City Turn car seat For further information reference the instruction manual PKG0001381133...

Page 2: ...LEVER ROTATION LEVER LOWER ANCHOR STORAGE FORWARD FACING BELT PATH TETHER INSTRUCTION MANUAL STORAGE RECLINE FOOT RECLINE LEVER 9 10 FORWARD FACING RAPIDLOCK CUPHOLDER REAR FACING LEVEL INDICATOR REA...

Page 3: ...forward facing position The recline foot is secure when it CLICKS into place 6 Route seat belt through the forward facing belt path 2 Adjust the recline foot between positions 1 3 by squeezing the re...

Page 4: ...2 5 cm at the belt path CHECK THE LEVEL INDICATOR IN REAR FACING MODE PLACE CHEST CLIP AT ARMPIT LEVEL Not too high or too low CHECK HARNESS HEIGHT REAR FACING Harness straps should be at or below the...