57
3
h
Pull down the buttonhole lever as far as
possible.
a
Buttonhole lever
The buttonhole lever should be positioned
behind the bracket on the buttonhole foot.
a
Buttonhole lever
b
Bracket
i
Gently hold the end of the upper thread in
your left hand, and then start sewing.
X
Once sewing is completed, the
machine automatically sews
reinforcement stitches, then stops.
j
Cut the threads, raise the presser foot lever,
and then remove the fabric.
k
Raise the buttonhole lever to its original
position.
l
Insert a pin along the inside of one bar tack at
the end of the buttonhole stitching to prevent
the stitching from being cut.
a
Pin
m
Use the enclosed seam ripper to cut towards
the pin and open the buttonhole.
a
Seam ripper
For keyhole buttonholes (
), use the enclosed
eyelet punch to make a hole in the rounded
end of the buttonhole, and then use the seam
ripper to cut open the buttonhole.
a
Eyelet punch
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
■
Changing the stitch length
Press the “+” or “–” side of the stitch length key to
adjust the stitch length.
a
Stitch length key
b
Stitch length
c
Fine
d
Coarse
• If the fabric does not feed (for example, if it is
too thick), increase the coarseness of the
stitching.
a
a
b
a
●
When opening the buttonhole with the seam
ripper, do not place your hands in the cutting
path, otherwise injuries may result if the seam
ripper slips. Do not use the seam ripper in any
other way than how it is intended.
a
a
CAUTION
–
+
