UTILITY STITCHES
————————————————————————————————————————————————————————————————————
82
f
Position the side cutter so that the side cutter
pin is aligned with the notch in the presser
foot holder, and then slowly lower the presser
foot lever.
a
Notch in presser foot holder
b
Pin
X
The side cutter is attached.
g
Raise the presser foot lever to check that the
side cutter is securely attached.
h
Pass the upper thread under the side cutter,
and then pull it out toward the rear of the
sewing machine.
i
Make a cut of about 2 cm (3/4 inch) long
in the fabric at the beginning of the
stitching.
a
2 cm (3/4 inch)
j
Position the fabric.
Position the fabric so that the right side of the cut is
on top of the guide plate and the left side of the cut is
underneath the presser foot.
a
Guide plate
Note
●
If the fabric is not positioned correctly, the
fabric will not be cut.
●
After adjusting the stitch width, slowly turn
the handwheel toward you and check that the
needle does not touch the presser foot. If the
needle hits the presser foot, the needle may
bend or break.
a
b
CAUTION
a
a
