Inserting the Bobbin
1. Place the bobbin into the bobbin holder
with the thread running off as illustrated.
2. Guide the thread into the front notch on the
front side of the bobbin holder.
Draw the thread to the left, sliding it
between the tension spring blades .
3. Continue to draw the thread lightly
until the thread slips into the side notch .
1
3
2
5
4
4. Pull out about 4" of thread .
Attach the hook cover plate by inserting
the two prongs on left of hook cover
plate into the openings. Lower the right
side until it clicks into place. Check the
threading by referring to the chart shown
on the hook cover plate.
5
6
1
2
3
4
5
6