Winding/Installing the Bobbin
27
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
b
Cut the thread with scissors beside the bobbin-
winding thread guide.
a
Bobbin-winding thread guide
c
Slide the bobbin winder shaft to the left, and
then remove the bobbin from the shaft.
d
Hold the thread end with your left hand, and
wind off the thread clockwise near the bobbin
with your right hand as shown below.
e
Wind the bobbin again.
Note
z
Make sure that the thread passes under the
pretension disk of the bobbin-winding
thread guide correctly (page 24).
Installing the bobbin
Install the bobbin wound with thread.
CAUTION
Memo
z
The order that the bobbin thread should be
passed through the bobbin case is indicated
by marks that surround the bobbin case.
a
●
Use a bobbin that has been correctly
wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.
●
The included bobbin was designed
specifically for this sewing machine. If
bobbins from other models are used, the
machine will not operate correctly. Use
only the included bobbin (part code:
X52800-120) or bobbins of the same type
(Class 15 plastic bobbins).
This model
Other model
11.5 mm
(7/16 inch)
Actual size
0711-0120-C-combo_E.book Page 27 Tuesday, August 26, 2008 2:43 PM
Summary of Contents for A-LINES Sofia BL137A
