Baby Lock Amelia BL100A, Getting To Know Manual

1.  Remove the bobbin cover by sliding the bobbin cover latch to the right and push down the

      left lower corner of the bobbin cover at the same time.

2.   Remove the bobbin from the machine. 

1.   Slightly raise horizontal spool pin.
2.   Slide a spool of thread onto the spool pin so the thread unwinds to the front from the top

      of the thread spool. Secure it with the spool cap that best fits the size of the spool being used to

      ensure smooth flow of thread.
3.   Pass thread from spool around and under the upper thread guide as shown.
4.   Pull end of thread through hole in bobbin as shown.    
5.    Make sure the bobbin winder shaft is in left position. Place bobbin onto shaft and rotate until it

      snaps into position with end of thread coming from top of bobbin.
6.   Start machine to wind bobbin. Stop machine after several turns to trim the thread tail with scissors.

      Bobbin will cease turning when completely filled. Cut thread and push shaft to the left to remove

      bobbin.    

Winding the Bobbin

1

removing the Bobbin

Winding the Bobbin