-9-
1.
DISASSEMBLING AND REASSEMBLING THE OUTER PARTS AND MAIN
PARTS
Disassembly procedure
1.
Remove the screws holding the face plate, then remove the face plate to the left.
2.
Remove the flat bed attachment by sliding it to the left.
3.
Remove the six screws holding the front cover (three on the rear, two on the bottom, one of the left), then lift
up the front cover from the bottom side, open it forward, and remove it.
4.
Lower the presser lifter, remove the four screws holding the rear cover (two on front, one on rear, and one
on bottom), and then remove the rear cover. Remove the handle too.
